• 12 Answers SOURCE: Can you give more details? Are you saying it stops 7 seconds after you step on it, (every time)? If so, have you had the treadmill a while? This is an indicator of a worn belt. The belt is not sliding like it should, and drawing too much current. Your control board will 'clip' the current off after a pre-set time, to avoid burning up components. Find best value and selection for your Manual Sportcraft TX 4 9 Treadmill search on eBay. World's leading marketplace. EX 400 Installation Manual SPORTCRAFT EX 400 Quick Start Guide Manual sportcraft elliptical ex200 - user's guide User's Guides, Owner's Manuals, Service Manuals, Instructions Books - The largest database - Immediate download or research services Elliptical machines sportcraft treadmill Manual Elliptical Machine $40.00. Other things it could be: 1. Your belt is too tight. Did you tighten it lately? When did your treadmill start doing this? Sportcraft![]() The motor is going bad, and drawing too much current. Motor control board is bad. Look at your motor's current rating: measure the current draw when you get on it. If the current draw is ~ 80% of the rated current of the motor, and your belt is good.and not too tight, it could be the motor. If the treadmill is stopping while only drawing 4 or 5 amps, I would lean towards the control board is bad. Download save game patapon 3 psp. Cheapest way to get started troubleshooting. Ensure the belt is not too tight, (adjust to only about 3 inches slack, when you pull up on it). Buy some belt lubricant and lube it up. If this doesn't fix your problem, keep looking for other fixya help. Someone with SportCraft TX 2.5 specific experience. Sorry, I only have generic help here. Posted on Jan 27, 2010. • 218 Answers SOURCE: You will need to check the speed sensor for proper alignment and function. It should be located near the front roller or mounted on the motor. It should be within a credit cards width of the magnet or toothed wheel. If properly adjusted check with an ammeter to see if it is opening and closing by manually spinning the front roller or motor flywheel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |